INSTRUCTIONS

The following instructions are for the Original StrikePack for XBOX One. For instructions on how to use the Original StrikePack after the Dominator upgrade, download the instructions PDF on our support page.

ON THE FLY PADDLE MAPPING

  • To MAP the paddles, simply hold down the appropriate left or right programming button (P1 – LEFT Assignment; P2 – RIGHT Assignment). While still holding the programming button simply PRESS the button you want to assign. To save that button as the designated choice simply LET GO of the button. If say, you wanted to assign the button to the right paddle, just press & hold the P2 programming button and PRESS the ” Y ” button now. Once you release the ” Y ” button, it has been assigned to the right paddle. To map the left paddle, follow the same process, but use the P1 programming button instead.
  • The following buttons can be mapped in this method:

mapped_button

GAMEPACK OPERATION

Bank Selection:

  • To select a bank slot, Press and HOLD left programming button (P1)
  • Tap the right programming button (P2) to cycle to the desired bank slot – LED of that bank will be ON
  • Release P1 to choose the desired bank slot – LED of that bank will remain ON
  • Cycle one position after the 8th bank to turn off fully.  This ensures that GamePack mode is completely off– No LED’s ON

Quick Enable/Disable MOD’s:

Quick Enable

  • All Banks: NO LED’s – All MODS are disabled
  • Bank 1-8: LED ON – GamePack enabled on that bank
  • Left Bank: LED ON represents storage banks 1-4
  • Right Bank: LED ON represents storage banks 5-8
  • Left Bank: Flashing WHITE LED – Current CLASS #
  • Right Bank: Flashing GREEN LED – Current MOD #

On the Fly GamePack Configuration

To Enter Menu Mode:

Xbox ONE: Hold VIEW+MENU for 2 seconds to enter in menu mode.

IMPORTANT

Always keep the VIEW button pressed while in Menu mode. To exit the menu mode, release the VIEW button.

  • Left Bank: Flashing WHITE LED – Current CLASS #
  • Right Bank: Flashing GREEN LED – Current MOD #

NOTE

See below for instructions how to navigate between Classes and MOD’s. You can also pre-configure your GamePack settings using the GamePack Configuration Interface in your Strike Command Software.

To Navigate Between Classes: To Navigate Between Classes:

To Navigate Between MOD’s Within Current Class:

Adjustable MOD’s (Rapid Fire, Quick Scope, Secondary Rapid Fire and Anti-Recoil): mapped_button5mapped_button6mapped_button7

starwars mortalkombat gta5 farcry4 dyinglights desitny COD3 COD_AW 60secs

Pin It on Pinterest

Share This